Plastic Tipped Lift Pins
- protective contact surfaces for fragile or sensitive substrates
- PTFE / Teflon™ tips: 200°C maximum process temperature
- Vespel® tips: 300°C maximum process temperature
- load vertically; avoid sliding wafers across the tips
- both tip materials fit Apogee® 200 and 300 Bake Plates
Product Information
Overview
Cee® Plastic Tipped Lift Pins provide a softer contact surface for substrate handling on Apogee® Bake Plates. Designed for applications involving fragile or sensitive materials, they reduce contact stress during loading, unloading, and processing while maintaining reliable wafer support.
Key Capabilities
Plastic Tipped Lift Pins replace standard lift pins with compliant tip materials to reduce contact stress at the substrate interface.
Key capabilities include:
- Enhanced substrate protection for fragile, thin, or sensitive materials
- Reduced risk of scratching or surface marking during wafer handling
- Low-friction contact surfaces support smooth loading and unloading
- Available in multiple material options to match thermal requirements and process conditions
Two material configurations are available:
- PTFE (Teflon™) Tipped Lift Pins – Maximum operating temperature of 200 °C
- Vespel® Tipped Lift Pins – Maximum operating temperature of 300 °C
These options allow users to balance substrate protection with thermal process requirements.
Plastic Tipped Lift Pins are typically used in specialized applications where substrate sensitivity is critical. Standard lift pins remain suitable for most silicon and general-purpose applications.
Safety & Facilities
Plastic Tipped Lift Pins introduce temperature limitations based on material selection. Users must ensure that bake temperatures do not exceed the rated limits of the installed lift pin material to prevent degradation or damage.
Care should be taken during substrate loading to place wafers vertically onto the pins. Lateral movement or sliding contact can damage the pin tips and reduce performance over time.
No additional facility requirements are needed beyond standard bake plate operation. Neither plastic tip material is suitable for 400°C processing. Inspect tips for wear, deformation, looseness, and contamination; replace damaged tips using an approved Cee® procedure.
Compatibility
The Cee® Plastic Tipped Lift Pins are available for all Apogee® mounting configurations, including benchtop, flange-mount, and integrated workstation installations.
Apogee® 200 Bake Plate
Apogee® 300 Bake Plate
What's in the Box
- 3 Plastic Tipped Lift Pins (configured in equipment)
- 2 Stop Pins
- Installation/Operations Manual
Specs
PTFE / Teflon™ or Vespel®
200°C maximum
300°C maximum
You May Also Like