Waste Diverter
- routes process waste between two separate discharge paths
- separates aqueous, solvent-based, and other incompatible waste streams
- recipe-controlled pneumatic switching through DataStream™
- normally open primary drain path with spring return
- compatible with Apogee® 200 and 450 Spin Coaters and Spin Developers
Compatibility: Apogee® 200 and 450 Spin Coaters and Spin Developers
Waste Diverter SKU: 902805
Product Information
Overview
The Cee® Waste Diverter routes process waste from Apogee® Spin Coaters and Spin Developers to one of two separate discharge paths. This enables segregation of incompatible chemistries, such as aqueous and solvent-based waste, at the equipment drain.
Key Capabilities
- directs waste between primary and secondary drain outlets
- recipe-controlled through DataStream™ dispense commands
- pneumatic spring-return actuation
- normally open primary outlet when the diverter is not commanded
- polypropylene wetted body with ¾ in drain hose-barb connections
When the assigned dispense command is enabled in a recipe, the diverter switches waste to its secondary outlet. When that command is disabled, it returns to the primary outlet. Recipes without a diverter command route waste to the primary output by default.
Safety & Facilities
Separate collection paths help facilities manage incompatible or differently regulated waste streams. Verify compatibility of chemicals with the polypropylene wetted body and downstream hoses and containers. The diverter uses a pneumatic actuator supplied through the four-position dispense control box. Nitrogen or clean dry air (CDA) must meet the control system requirements, including a minimum 70 psi actuation pressure. Verify both waste paths remain unobstructed and connect to appropriate collection systems.
Compatibility
Compatible with Apogee® 200 and 450 Spin Coaters and Spin Developers. Both series use the same drain interfaces. The assembly connects to the equipment’s rear drain connection; allow approximately 8.5 inches of additional rear depth for installation.
What's in the Box
- waste diverter with pneumatic spring-return actuator
- integrated ¾ in drain hose-barb connections
- quick-connect coupling for the equipment drain interface
- 1/8 in pneumatic control tubing for installation
- installation/operations instructions
Specs
Polypropylene (wetted valve body)
Pneumatic actuation with spring return
Normally open to primary waste outlet
Add 8.5 inches to equipment’s standard depth
Recipe-controlled through DataStream™ as a dispense command
Pilot pressure supplied through four-position dispense control box
2- 3/4 in hose-barb waste outlets
You May Also Like